A periodic test notice will be applied to your mains board indicating the next due test date. We hold records of all clients, together with re-test dates on our database and remind clients when re-tests are due. Logic will notify you automatically 3 months prior your testing due date.
Because we accurately identify any faults found, the cost of remedy in most cases is not too great. The majority of problems found involve earthing deficiencies, which although potentially very dangerous are not usually hugely expensive to remedy.
The Electricity at Work Regulations applies to all businesses from multi-nationals to sole traders. So you still need to comply.
Unless and until you suffer an accident then probably nothing will happen. However, remember that maintenance of a safe electrical system is a legal requirement. Therefore a preventable accident could lead to prosecution, for which there will be no insurance cover.
You may also find that an insurance loss adjuster could make much of the fact that you may not have maintained the system adequately which could have led to the claim. Again, this could lead to an unsuccessful claim and a costly experience.
As per the IEE Regulations, you can only rely on sample testing if you hold previous full system records, the installation is considered to be in excellent condition, no faults are found during sample testing and no undocumented alterations have been carried out since the system was new or last tested. This does not hold true for the vast majority, for which full inspection and testing should be undertaken.
You are responsible to make sure that you and your staff complies with Health & Safety legislation. However, it is usually dependent on the terms of your lease as to whether you or your landlord pays for testing to be carried out on the electrical installation. Usually, if you are on a full repairing lease then the cost will fall to you. Portable Appliance testing will always be at your expense.
Costs are based on a cost per circuit or appliance tested multiplied by the numbers involved. This, together with the existing condition of and accessibility to the system will determine the overall cost. Please contact us on 017683 51812 to assess your portable appliance testing or electrical testing needs further.
There has always been a requirement to satisfy Health & Safety legislation. In 1989 The Electricity at Work Regulations came into force, which clarifies the need to maintain electrical systems safely. So there has always been the need and test data results will form a major part of your defense should an accident occur which leads to prosecution.
A visiting inspector will not necessarily identify the need to maintain electrical safety at every inspection he makes, especially if there are other issues to be addressed. Because testing has not been specifically demanded does not mean that the legal requirements to comply with electrical safety do not apply.
Increasingly, insurers are insisting that inspection and testing be carried out on a regular basis. If an avoidable accident or a fire occurs where electricity is suspected to have been the cause, then under law if found guilty you will be deemed to have committed a criminal offence. Insurers will not pay fines or compensation suffered resulting from a criminal offence.
If the Periodic Inspection Report recommends improvements to the installation, Logic will provide a fixed price quotation for the remedial work to be carried out if you require one.
An Electrical Installation Condition Report (EICR) is a formal method of recording the findings of the periodic inspection, on at least seven pages.
The main purpose of a EICR is to report on the safety condition of an existing installation. Box E on page 1 should describe the overall condition as either ’satisfactory’, in which case no immediate remedial work is required, or ‘unsatisfactory’ which means remedial work is required to make the installation safe to use.
A short power outage can be expected on each circuit within the system. But because most of the testing is carried out whilst the system is still live, these outages can be planned around your daily activities.
The NICEIC Approved Contractor will check the electrical installation against the requirements of BS7671 – Requirements for Electrical Installations ( IEE Wiring Regulations) – as amended, which is the national safety standard for electrical installations, and contains around 850 Regulations.
The period inspection will take into account all relevant circumstances including the following factors:
• Adequacy of earthing and bonding
• Suitability of the switchgear and controlgear e.g. consumer unit e.g. an old fusebox with a wooden back, cast iron switches, a haphazard mixture of such equipment is likely to need replacing
• Serviceability of equipment e.g. switches, socket-outlets and light fittings e.g. older round pin sockets, round light switches and braided flex hanging from ceiling roses to light fittings, black switches, sockets mounted in skirting boards may require replacing
• Type of wiring system and its condition e.g. cables coated in black- rubber, black-rubber was phased out in the 1960s or cables coated in lead or fabric are even older and may need replacing (modern cables use pvc insulation)
• Provision of residual current devices for socket-outlets that may be used to plug in electrical equipment used outdoors
• Presence of adequate identification and notices
• Extent of any wear and tear, damage or other deterioration
• Changes in use of the premises which have led to, or might lead to, deficiencies in the installation
The Approved Contractor will provide an Electrical Installation Condition Report (EICR) as part of the periodic inspection.
Periodic inspections are best left to an experienced electrician or electrical engineer who holds a City and Guilds 2391 – Inspection, Testing and Verification of electrical installations with relevant experience in the installation types being tested.
It is recommended that periodic inspection and testing is carried out at least every:
• 10 years for a domestic installation
• 5 years for a commercial installation
• 3 years for caravans
• 1 year for swimming pools
Other instances when a periodic inspection should be carried out are:
• when a property is being prepared to be let
• prior to selling a property or when buying a previously occupied property
• where there is reason to believe that damage has been cause to the building such as flooding or fire
Every electrical installation deteriorates with use and age. It is important for the person responsible for the maintenance of the installation to be sure that the safety of users is not put at risk, and that the installation continues to be in a safe and serviceable condition.
According to Government statistics, each year on average 10 people die and about 750 are seriously injured in accidents involving unsafe electrical installations in the home.
A Periodic Inspection is an inspection on the condition of an existing electrical installation, to identify (in order of priority) any deficiencies against the national safety standard for electrical installations.
A periodic inspection will:
• reveal if any of your electrical circuits or equipment is overloaded
• find any potential electrical shock risks and fire hazards in your electrical installation
• identify any defective DIY electrical work
• highlight any lack of earthing or bonding
Tests are also carried out on wiring and associated fixed electrical equipment to check that it is safe.
I have been very impressed by "Logic". They have done their utmost to resolve my heating problems & everyone in the firm from the top down has been very helpful & pleasant. I would not hesitate to recommend the firm - a big thank you!
Always great service and the engineer arrived when he said, the boiler works better than before, so thank you all
We have used Logic for over twelve years and always had excellent and prompt service. We have recommended to friends.